Setting The 8-Bit Configuration Switch - Agilent Technologies 1100 Series Reference Manual

Setting the 8-bit Configuration Switch

The 8-bit configuration switch is located next to the GPIB connector. Switch
settings provide configuration parameters for GPIB address, serial
communication protocol and instrument specific initialization procedures.
Factory setting is shown
for the diode array
detector or multiple
wavelength detector
Figure 66
Table 40
Mode Select
GPIB
RS-232C
Reserved
TEST/BOOT
Switches 1 and 2 define which set of parameters (for example, for GPIB,
RS-232C, and so on) will be changed. Once the change has been completed, the
instrument must be powered up again in order to store the values in the
non-volatile memory.
1100 Series DAD and MWD Reference Manual
8-bit Configuration Switch
8-bit Configuration Switch
1 2 3
0 0
0 1 Baud rate
1 0 Reserved
1 1 RSVD
Introduction to the Detector
4 5 6
GPIB Address
Data
Bits
SYS RSVD
6
7 8
Parity
RSVD FC
261