Function (Operation / Inspection Mode) - Canon imageRUNNER ADVANCE C3330 Series Service Manual

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > EXP-LED
INTEXP-C 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
INTEXP-K 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit

FUNCTION (Operation / inspection mode)

■ INSTALL
COPIER (Service mode for copier) > FUNCTION (Operation / inspection mode) > INSTALL
STIR-Y 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
STIR-M 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
Adj Cln Pre-expo LED(C) initial intnsty
To adjust the initial light intensity of the Cleaning Pre-exposure LED (C).
When replacing the LED, enter the value written on the label included in the package of a new
one.
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
- When replacing the Cleaning Pre-exposure LED
- When replacing the DC Controller PCB/clearing RAM data
Enter the setting value, and then press OK key.
Use this item only when replacing the Cleaning Pre-exposure LED or replacing the DC Controller
PCB/clearing RAM data.
0 to 100
%
0
1
Adj Cln Pre-expo LED(Bk) initial intnsty
To adjust the initial light intensity of the Cleaning Pre-exposure LED (Bk).
When replacing the LED, enter the value written on the label included in the package of a new
one.
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
- When replacing the Cleaning Pre-exposure LED
- When replacing the DC Controller PCB/clearing RAM data
Enter the setting value, and then press OK key.
Use this item only when replacing the Cleaning Pre-exposure LED or replacing the DC Controller
PCB/clearing RAM data.
0 to 100
%
0
1
Stirring of Y-color developer
To stir developer in the Y-color Developing Unit.
When fogging occurs on an image after the machine has not been used for a long time
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
150 sec
COPIER> FUNCTION> INSTALL> STIR-M/C/K/4
Stirring of M-color developer
To stir developer in the M-color Developing Unit.
When fogging occurs on an image after the machine has not been used for a long time
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
150 sec
COPIER> FUNCTION> INSTALL> STIR-Y/C/K/4
810
8. Service Mode