Canon imageRUNNER ADVANCE C3330 Series Service Manual page 646

31-0030
A. Operation / B. Cause /
C. Remedy
31-0057
A. Operation / B. Cause /
C. Remedy
34-0003
A. Operation / B. Cause /
C. Remedy
34-0024
A. Operation / B. Cause /
C. Remedy
34-0026
A. Operation / B. Cause /
C. Remedy
34-0034
A. Operation / B. Cause /
C. Remedy
34-0036
A. Operation / B. Cause /
C. Remedy
34-0044
A. Operation / B. Cause /
C. Remedy
34-0046
A. Operation / B. Cause /
C. Remedy
34-0050
A. Operation / B. Cause /
C. Remedy
34-2201
A. Operation / B. Cause /
C. Remedy
The configuration of an option controlled by the DCON has been changed
Due to a change in the configuration related to the printer, a change in the hardware configuration
which requires turning OFF and then ON the power was detected.
Detection condition/timing:At the time of startup only
Remedy:Turn OFF and then ON the main power.
Condensation alarm
-
Auto registration adjustment
Timeout occurred due to unsuccess in reading 10 sets of auto registration pattern.
Registration Patch Sensor failure, Registration Patch Sensor cleaning member covered the
registration detection sensor, or no image drew on the ITB.
The correction value (M) of the write start position in the vertical scanning direction
exceeded the upper limit during color fine adjustment
-
The correction value (M) of the write start position in the horizontal scanning direction
exceeded the upper limit during color fine adjustment
-
The correction value (C) of the write start position in the vertical scanning direction
exceeded the upper limit during color fine adjustment
-
The correction value (C) of the write start position in the horizontal scanning direction
exceeded the upper limit during color fine adjustment
-
The correction value (Bk) of the write start position in the vertical scanning direction
exceeded the upper limit during color fine adjustment
-
The correction value (Bk) of the write start position in the horizontal scanning direction
exceeded the upper limit during color fine adjustment
-
Laser Scanner EEPROM checksum alarm
An error in data in the EEPROM installed in the Laser Scanner PCB was detected.
Detection condition/timing:
When the DCON is started, data in the EEPROM of the Laser Scanner is retrieved.
[Related parts]
- YM Laser Driver PCB
- Harness (FM1-D837) between the DC Controller PCB (UN04/J111) and the YM Laser Driver
PCB (J202)
Remedy:
[Remedy] Check/replace the related parts.
[Caution] After replacing the related parts, execute "Settings/Registration> Adjustment/
Maintenance> Adjust Image Quality> Auto Correct Color Mismatch".
As a result of wrong detection processing, data that can be used for correction in the
vertical scanning direction was not found (M)
-
634
7. Error/Jam/Alarm