Canon imageRUNNER ADVANCE C3330 Series Service Manual page 996

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
ST-ALG1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
SW-UP-RL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
PRCS-RET 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
UP-CL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Adj Processing Tray align pstn: Fin-U1
To adjust the alignment position of the Stack Tray.
As the value is incremented by 1, the travel length of the Alignment Plate is increased by 0.42 mm.
When misalignment occurs in the Processing Tray
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-10 to 10
mm
0
0.42
Adj of Swing Roller descent pstn: Fin-U1
To adjust the Swing Roller down position.
When the value is increased by 1, the descent position of Swing Roller moves downward by 0.2
mm.
When paper fails to be transported to the Processing Tray and misalignment occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-17 to 33
mm
0
0.2
Adj Process Tray return amount: Fin-U1
To adjust the return amount of the paper on the Processing Tray.
When the value is increased by 1, the return amount is decreased by 1.4 mm.
When the paper is bent in the Processing Tray
Enter the setting value, and then press OK key.
0 to 5
mm
0
SORTER> OPTION> PRCS-SP3
1.4
Setting of upward curl prev mode: Fin-U1
To set ON/OFF of upward curl prevention mode.
Set to 1 when a paper leaning occurs due to upward curl on the paper delivered to the Stack Tray.
When 1 is set, downward curl prevention mode (DW-CL) is disabled.
When upward curl occurs on the paper delivered to the Stack Tray, and paper leaning due to the
curl occurs
Enter the setting value, and then press OK key.
0 to 1
0: OFF, 1: ON
0
SORTER> ADJUST> DW-CL
984
8. Service Mode