Canon imageRUNNER ADVANCE C3330 Series Service Manual page 849

COPIER (Service mode for copier) > OPTION (Specification setting mode) > FNC-SW
BK-4CSW 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
MODELSZ2 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
SVMD-ENT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set simple full clr mode: 1/2 SPD, Bk-m
To set whether to switch single Bk-color mode to simple full color mode at 1/2 speed.
In single Bk-color mode, shock image at 64 mm from the leading edge may occur due to impact
triggered by paper entering the secondary transfer section.
In simple full color mode, black is created by using small amount of Y, M and C toners so that
shock image can be alleviated.
When shock image occurs in single Bk-color mode at 1/2 speed
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Even 1 is set, if there is no Y/M/C-color toner or when color printing is limited after occurrence of
an error, it is not switched to simple full color mode. The setting is enabled by setting a toner
cartridge or solving the failure that causes colors being limited.
0 to 1
0: OFF, 1: ON
0
Ppr size dtct global support in bookmode
To set ON/OFF for global support of document size detection in copyboard reading mode.
Upon user's request (mixed media original with AB/Inch configuration)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
The Document Size Sensor (Photo Sensor) is additionally required to correctly detect the
document size when the original consists of mixed media (AB/Inch configuration).
0 to 1
0: Detected with detection size according to location, 1: Detected with AB/Inch mixed media.
It differs according to the location.
Setting of entry method to service mode
To set the way to get in service mode to prevent information leak.
As needed
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Factory default
1: [Settings/Registration] - Pressing [4] and [9] at the same time - [Settings/Registration]
0
837
8. Service Mode