Canon imageRUNNER ADVANCE C3330 Series Service Manual page 788

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > HV-TR
T2TR-LNG 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Amount of Change per
Unit
B2TR-LNG 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Amount of Change per
Unit
1ATVCTMG 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Amount of Change per
Unit
Adj of lead edge weak bias apply length
To adjust the length (distance from the leading edge of paper) to apply leading edge weak bias.
Increase the value when white spots occur in a broad area of the leading edge of paper.
When an image failure (white spots at the leading edge) occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Use this item only when an image failure occurs.
-100 to 100
mm
-40 - 40
0
0.1
Adj of trail edge weak bias apply length
To adjust the length (distance from the trailing edge of paper) to apply trailing edge weak bias.
Increase the value when white spots occur in a broad area of the trailing edge of paper.
When an image failure (white spots at the trailing edge) occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Use this item only when an image failure occurs.
-100 to 100
mm
-40 - 40
0
0.1
Adj pry trns ATVC ctrl exe intvl: 1/2SPD
To adjust the intervals (the number of sheets) to execute primary transfer ATVC control at 1/2
speed.
Decrease the value if the condition of image failure occurrence caused by primary transfer is as
follows:
- It does not occur at 1/1 speed, but occurs at 1/2 speed.
- It is alleviated by executing primary transfer ATVC control.
- It is temporarily alleviated when continuing output, but it occurs again.
These indicate that primary transfer ATVC control is not executed at 1/2 speed.
Image failure can be alleviated by increasing the frequency to execute primary transfer ATVC
control, but productivity at 1/2 speed decreases.
When an image failure or blocky image at 50 mm intervals occurs at 1/2 speed
Enter the setting value, and then press OK key.
As the value is smaller, productivity at 1/2 speed decreases. As the value is increased, productivity
is increased, but image failure may occur.
100 to 2000
sheet
300 - 1500
1000
1
776
8. Service Mode