Canon imageRUNNER ADVANCE C3330 Series Service Manual page 756

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > BLANK
BLANK-R
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
BLANK-B
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
BLANK-B2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
1 Adjustment of right edge margin
To adjust the margin on the right edge of paper.
As the value is incremented by 1, the margin is increased toward the center of the paper by 1 pixel
(0.0423 mm).
- When reducing the margin upon user's request
- When increasing the margin for transfer separation/fixing separation
Enter the setting value, and then press OK key.
0 to 1000
pixel
59
1
1 Adj end edge margin: excpt thin, rcycl 2
To adjust the trailing edge margin of paper other than thin paper/recycled paper 2.
As the value is incremented by 1, the margin is increased toward the center of the paper by 1 pixel
(0.0423 mm).
- When reducing the margin upon user's request
- When increasing the margin for transfer separation/fixing separation
Enter the setting value, and then press OK key.
0 to 1000
pixel
60
59
COPIER> ADJUST> BLANK> BLANK-B2
Adjust the trailing edge margin of thin paper/recycled paper 2 with BLANK-B2.
1
2 Adj of trailing edge margin:thin/rcycl 2
To adjust the margin on the trailing edge of thin paper/recycled paper 2.
As the value is incremented by 1, the margin is increased toward the center of the paper by 1 pixel
(0.0423 mm).
Increase the value when blur at leading edge/wrinkles occur with thin paper/recycled paper 2.
A value to which the setting value of BLANK-B is added is applied as the margin.
- When increasing the margin of thin paper/recycled paper 2 upon user's request
- When blur at leading edge/wrinkles occur with thin paper/recycled paper 2
- When increasing the margin for transfer separation/fixing separation
Enter the setting value, and then press OK key.
Be sure to set a value where the setting value of BLANK-B is deducted from the target value.
0 to 1000
pixel
JP:0, USA:0, EUR:35, AU:0, CN:0, KR:0, TW:0, ASIA:0
COPIER> ADJUST> BLANK> BLANK-B
Blur at leading edge: A phenomenon that the image leading edge on the 2nd side is blurred at 2-
sided print. It is likely to occur on image with high density. Contact of curled portion of paper leading
edge with the Fixing Film causes the phenomenon. When the degree of curl is increased, it is
accompanied with wrinkles.
Adjust the trailing edge margin of paper other than thin paper/recycled paper 2 with BLANK-B.
1
744
8. Service Mode