Canon imageRUNNER ADVANCE C3330 Series Service Manual page 958

COPIER (Service mode for copier) > OPTION (Specification setting mode) > LCNS-TR
TR-OPFNT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Supplement/Memo
ST-NCAPT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-NCAPT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-U-RDS 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
TR-U-RDS 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Transfer license key dspl: PCL Font Set
To display transfer license key to use PCL Font Set when the function is disabled with license
transfer.
- When replacing the HDD
- When replacing the device
1) Select ST-OPFNT.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-OPFNT.
24 digits
PCL Font Set can be installed only at installation by service technician or at pre-installation.
When replacing the HDD, check that AndaleFont is displayed by going through the following:
Settings/Registration> Function Settings> Printer> Output Report> PCL> Font List.
Install state display of NetCap function
To display installation state of network packet capture function when disabling the function with
license transfer.
When checking whether network packet capture function is installed
1) Select ST-NCAPT.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-NCAPT.
When operation finished normally: OK!
According to the setting at shipment
Transfer license key dspl of NetCap func
To display transfer license key to use network packet capture function when the function is disabled
with license transfer.
- When replacing the HDD
- When replacing the device
1) Select ST-NCAPT.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-NCAPT.
24 digits
Install state display of E-RDS function
To display installation state of Embedded-RDS function when disabling the function with license
transfer.
When checking whether Embedded-RDS function is installed
1) Select ST-U-RDS.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-U-RDS.
When operation finished normally: OK!
According to the setting at shipment
COPIER> FUNCTION> INSTALL> E-RDS
Trns license key dspl of E-RDS function
To display transfer license key to use Embedded-RDS function when the function is disabled with
license transfer.
- When replacing the HDD
- When replacing the device
1) Select ST-U-RDS.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-U-RDS.
24 digits
946
8. Service Mode