Canon imageRUNNER ADVANCE C3330 Series Service Manual page 823

COPIER (Service mode for copier) > FUNCTION (Operation / inspection mode) > INSTALL
STIR-C 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
STIR-K 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
STIR-4 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Required Time
Related Service Mode
STRD-POS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Required Time
Related Service Mode
Supplement/Memo
CARD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Stirring of C-color developer
To stir developer in the C-color Developing Unit.
When fogging occurs on an image after the machine has not been used for a long time
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
150 sec
COPIER> FUNCTION> INSTALL> STIR-Y/M/K/4
Stirring of Bk-color developer
To stir developer in the Bk-color Developing Unit.
When fogging occurs on an image after the machine has not been used for a long time
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
150 sec
COPIER> FUNCTION> INSTALL> STIR-Y/M/C/4
Stirring of all colors of developers
To stir developer in the Developing Units of 4 colors (Y/M/C/Bk).
When fogging occurs on an image after the machine has not been used for a long time
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
150 sec
COPIER> FUNCTION> INSTALL> STIR-Y/M/C/K
Scan position auto adj in DADF mode
To adjust the DADF scanning position automatically.
At DADF installation/uninstallation
1) Close the DADF.
2) Select the item, and then press OK key.
Close the DADF until the operation automatically stops after the adjustment.
3) Write the value displayed by COPIER> ADJUST> ADJ-XY> STRD-POS in the service label.
- If the DADF is opened before the operation automatically stops, perform the operation again.
- Write the adjusted value in the service label.
At normal termination: OK, At abnormal termination: NG
10 sec
COPIER> ADJUST> ADJ-XY> STRD-POS
For the copyboard model, there is no need to adjust the reading position.
Setting of card number
To set the card number to be used for Card Reader.
A series of numbers from the entered number to the number of cards specified by CARD-RNG
can be used.
- At installation of the Card Reader
- After replacing the HDD
1) Enter the number, and then press OK key.
2) Turn OFF/ON the main power switch.
The card management information (department ID and PIN) is initialized.
0 to 2001
0
COPIER> OPTION> FNC-SW> CARD-RNG
811
8. Service Mode