Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1002

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
INF-ALG1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
INF-ALG2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
CENT-ALG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
Adj alignment position (A4): Fin-G1
To adjust the position of the Alignment Plate when aligning A4 paper.
As the value is incremented by 1, distance between the Alignment Plates is narrowed by 0.1 mm.
When the paper alignment position is displaced.
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
The Alignment Plate moves to the A4 paper width position.
2) Set A4 paper on the Processing Tray.
3) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
4) Check the operation of the Alignment Plate.
5) Repeat steps 3 and 4 until the completion of adjustment.
6) Remove the paper on the Processing Tray.
-50 to 50
mm
0
SORTER> ADJUST> INF-ALG2
The adjustment result is reflected in SORTER> ADJUST> INF-ALG2.
0.1
Adj alignment position (LTR): Fin-G1
To adjust the position of the Alignment Plate when aligning LTR paper.
As the value is incremented by 1, distance between the Alignment Plates is narrowed by 0.1 mm.
When the paper alignment position is displaced.
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
The Alignment Plate moves to the LTR paper width position.
2) Set LTR paper on the Processing Tray.
3) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
4) Check the operation of the Alignment Plate.
5) Repeat steps 3 and 4 until the completion of adjustment.
6) Remove the paper on the Processing Tray.
-50 to 50
mm
0
SORTER>ADJUST>INF-ALG1
The adjustment result is reflected in SORTER> ADJUST> INF-AL1.
0.1
Adj center align standard pstn: Fin-G1
To adjust the standard position for the center alignment
As the value is incremented by 1, the standard position for the center alignment moves by 0.1 mm.
+: Toward rear
-: Toward front
- When the standard position for the center alignment is misaligned
- When the paper alignment position is displaced.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Do not use this at the normal service to influence alignment operation and staple position. Adjust
the alignment width with INF-ALG1/2.
-10 to 10
mm
0
SORTER> ADJUST> INF-ALG1, INF-ALG2
0.1
990
8. Service Mode