Canon imageRUNNER ADVANCE C3330 Series Service Manual page 814

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > FEED-ADJ
LP-DUP2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
Amount of Change per
Unit
REG-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
EXT-SPD 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Adj pre-rgst arch amount: heavy, 2-sided
To adjust the arch amount before registration for paper belonging to a group of heavy papers fed
in 2-sided mode.
As the value is changed by 1, the arch amount is changed by 0.1 mm.
+: Increase
-: Decrease
When an image on the 2nd side of paper belonging to a group of heavy papers fed in 2-sided mode
is skewed
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-50 to 50
mm
0
Group of heavy papers: Heavy paper 1/2/3/4, coated paper 1/2/3, transparency, label, bond paper,
envelope, postcard
0.1
Adjustment of Registration Motor speed
To adjust the speed of the Registration Motor.
As the value is changed by 1, the speed is changed by 0.2%.
+: Increase
-: Decrease
As the value is reduced, blur image in the area of 60 to 70 mm from the trailing edge is alleviated.
When blur image occurs in the area of 60 to 70 mm from the trailing edge
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-5 to 5
%
0
0.2
Setting of delivery speed at 1/1 speed
To set the delivery speed of papers (thin paper 1, plain paper 1/2/3, colored paper 1, recycled
paper 1/2/3, pre-punched paper 1 and tracing paper) which are fed at 1/1 speed in the case of
delivering to the First/Second Delivery Tray.
Set 2 if misalignment occurs with the papers when delivering to the First Delivery Tray. Speed of
the Fixing Motor is reduced so that papers are stacked on the First Delivery Tray more gently.
Set 1 if trailing edges of papers with 297 mm (A4R) or less in length get caught on the delivery
outlet when delivering to the Second Delivery Tray. Speed of the Second Delivery Motor is
increased so that trailing edge of paper can pass through the delivery outlet.
Set 3 if both of the above symptoms occur.
- When misalignment occurs at delivery to the First Delivery Tray
- When trailing edge of paper get caught on the delivery outlet at delivery to the Second Delivery
Tray
Enter the setting value, and then press OK key.
When 2 or 3 is set, FCOT becomes longer.
0 to 3
0: Normal, 1: Increase the speed at delivery to the Second Delivery Tray, 2: Reduce the speed at
delivery to the First Delivery Tray, 3: Reduce the speed at delivery to the First Delivery Tray and
increase the speed at delivery to the Second Delivery Tray
0
802
8. Service Mode