Canon imageRUNNER ADVANCE C3330 Series Service Manual page 573

537-8002-02
Detection Description
Remedy
540-8001-02
Detection Description
Remedy
a. Front Alignment Motor error b. Rear Aligning Plate HP error
a. The Front Alignment Plate HP Sensor was not turned ON although 5 seconds had passed after
the Front Alignment Motor operation started.
b. The Rear Aligning Plate HP Sensor does not detect the rear aligning plate although the Rear
Aligning Plate Motor has been driven for 4 seconds.
a. INNER FIN-G1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Motor
- Front Alignment Plate HP Sensor (PS4)
- Front Alignment Motor (M3)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-U1/BOOKLET FIN-U1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate Motor
- Rear aligning plate drive mechanism
- Rear Aligning Plate HP Sensor (PI107)
- Rear Aligning Plate Motor (M104)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
a. Tray Shift Motor error b. Tray 1 timeout error
a. The Stack Tray Paper Height Sensor was not turned ON although 5 seconds had passed after
the Tray Shift Motor operation started.
b. The tray does not return to its home position although the Tray 1 Shift Motor has been driven
for 25 seconds.
- The tray does not move to the other area although the Tray 1 Shift Motor has been driven for 5
seconds.
a. INNER FIN-G1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Stack Tray Paper Height
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Tray Shift Motor
- Stack Tray Paper Height Sensor (PS9)
- Tray Shift Motor (M6)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-U1/BOOKLET FIN-U1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Tray 1 Paper Surface Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Tray 1 Shift Area Sensor PCB
- Harnesses and connectors from the Finisher Controller PCB to the Tray 1 Shift Motor
- Tray 1 drive mechanism
- Tray 1 Paper Surface Sensor (PI114)
- Tray 1 Shift Area Sensor PCB (PCB4)
- Tray 1 Shift Motor (M107)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
561
7. Error/Jam/Alarm