Canon imageRUNNER ADVANCE C3330 Series Service Manual page 706

COPIER (Service mode for copier) > DISPLAY (State display mode) > CCD
OFST-CL 2
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
■ DPOT
COPIER (Service mode for copier) > DISPLAY (State display mode) > DPOT
2TR-PPR 2
2TR-BASE 2
1TR-DC-Y 2
1TR-DC-M 2
1TR-DC-C 2
1TR-DC-K 2
LPWR-Y 2
LPWR-M 2
LPWR-C 2
LPWR-K 2
PVCONT-Y 2
PVCONT-M 2
PVCONT-C 2
PVCONT-K 2
■ DENS
COPIER (Service mode for copier) > DISPLAY (State display mode) > DENS
DENS-Y 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Appropriate Target Value
Related Service Mode
Amount of Change per
Unit
Img Sensor offset value (color)
To display the CMOS Sensor offset value at color scanning.
When image failure occurs at scanning in color mode
1 to 95
1 - 95
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
For R&D
Dspl Y-color toner density change ratio
To display the deviation of Y-color toner density from the target value in percentage (%).
If the deviation is not acceptable, E020 occurs. This may be caused by deterioration of the
developer, failure/disconnection of the Toner Density Sensor or error in toner supply system.
The value is updated upon print operation after power-on.
When analyzing the cause of image failure (density failure, fogging) and occurrence of E020
N/A (Display only)
-700 to 700
%
-300 - 300
COPIER> DISPLAY> DENS> SGNL-Y
0.01
694
8. Service Mode