Canon imageRUNNER ADVANCE C3330 Series Service Manual page 925

COPIER (Service mode for copier) > OPTION (Specification setting mode) > USER
MEAPSAFE 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
AFN-PSWD 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PTJAM-RC 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PDL-NCSW 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Setting of MEAP safe mode
To set safe mode for MEAP platform.
MPSF is displayed on the Control Panel in safe mode.
In safe mode, MEAP application is stopped while just the system application, which starts with
initial state, is activated. Logs for cause analysis of MEAP failure can be obtained.
Perform system recovery processing when MEAP platform fails to be activated due to resource
conflict between MEAP applications, service registration or use order.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Normal mode, 1: Safe mode
0
Setting of Set/Reg menu access limit
To set whether to restrict access to Settings/Registration menu.
When 1 is set, password entry of system administrator is required after pressing Settings/
Registration key.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Without restriction, 1: With restriction (password entry required)
0
Setting of auto reprint at PDL print jam
To set whether to automatically restart printing after clearing jam that occurs with PDL print.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Not restart printing automatically, 1: Restart
1
Set of card management for PDL print job
To set whether to make PDL print job be subject to card management by the Card Reader.
When 1 is set, PDL print is available only when the card ID of the card inserted to the Card Reader
matches the department ID.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: PDL print is available with no card inserted.
1: PDL print is available only when the card ID of the card inserted to the Card Reader matches
the department ID.
0
913
8. Service Mode