Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1001

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
FR-STP-Y 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
Amount of Change per
Unit
RBLT-PRS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
MSTP-2P 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj stpl free stpl pstn (F/R way):Fin-G1
To adjust the staple position for front/rear direction in the staple free stapling mode.
As the value is changed by 1, the staple position moves by 0.1 mm.
+: Toward rear
-: Toward front
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the staple position in front/rear direction is displaced in the staple free stapling mode
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-30 to 30
mm
0
Change the paper shift amount in the front/rear direction. The staple free stapler position is not
changed.
0.1
Adj return belt pressure: Fin-G1
To adjust the amount of pressure of the Return Belt.
As the value is changed by 1, the Return Belt is moved up or down by 0.1 mm so the amount of
pressure is increased or decreased.
+: Increase
-: Decrease
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the paper alignment position is displaced.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-10 to 10
mm
0
0.1
Adj manual stapling position: Fin-G1
To adjust the staple position for front/rear direction in the manual stapling mode.
As the value is changed by 1, the staple position moves by 0.1 mm.
+: Toward rear
-: Toward front
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the staple position in front/rear direction is displaced in the manual stapling mode
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-15 to 20
mm
0
0.1
989
8. Service Mode