Canon imageRUNNER ADVANCE C3330 Series Service Manual page 951

COPIER (Service mode for copier) > OPTION (Specification setting mode) > LCNS-TR
ST-PS 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-PS 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-PCL 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-PCL 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-PSLI5 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Install state display of PS function
To display installation state of PS function when disabling the function with license transfer.
When checking whether PS function is installed
1) Select ST-PS.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-PS.
When operation finished normally: OK!
According to the setting at shipment
Transfer license key dspl of PS function
To display transfer license key to use PS function when the function is disabled with license
transfer.
- When replacing the HDD
- When replacing the device
1) Select ST-PS.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-PS.
24 digits
Install state display of PCL function
To display installation state of PCL function when disabling the function with license transfer.
When checking whether PCL function is installed
1) Select ST-PCL.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-PCL.
When operation finished normally: OK!
0
Transfer license key dspl: PCL function
To display transfer license key to use PCL function when the function is disabled with license
transfer.
- When replacing the HDD
- When replacing the device
1) Select ST-PCL.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-PCL.
24 digits
Installation state display of PS/UFR II
To display installation state of PS/UFR II function when disabling the function with license transfer.
When checking whether PS/UFR II is installed
1) Select ST-PSLI5.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-PSLI5.
When operation finished normally: OK!
According to the setting at shipment
939
8. Service Mode