Canon imageRUNNER ADVANCE C3330 Series Service Manual page 960

COPIER (Service mode for copier) > TEST (Print test mode) > PG
DENS-Y 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
DENS-M 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
DENS-C 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
DENS-K 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
COLOR-Y 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
COLOR-M 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Adj of Y-color density at test print
To adjust Y-color density when performing test print (TYPE = 5).
As the value is larger, the image gets darker.
At test print (TYPE = 5)
Enter the setting value, and then press OK key.
0 to 255
128
Adj of M-color density at test print
To adjust M-color density when performing test print (TYPE = 5).
As the value is larger, the image gets darker.
At test print (TYPE = 5)
Enter the setting value, and then press OK key.
0 to 255
128
Adj of C-color density at test print
To adjust C-color density when performing test print (TYPE = 5).
As the value is larger, the image gets darker.
At test print (TYPE = 5)
Enter the setting value, and then press OK key.
0 to 255
128
Adj of Bk-color density at test print
To adjust Bk-color density when performing test print (TYPE = 5).
As the value is larger, the image gets darker.
At test print (TYPE = 5)
Enter the setting value, and then press OK key.
0 to 255
128
Setting of Y-color output at test print
To set whether to output Y-color at the time of test print.
The setting is applied to all types.
When setting COLOR-Y to 1 and COLOR-M/C/K to 0, a single Y-color is output.
At test print
Enter the setting value, and then press OK key.
0 to 1
0: Not output, 1: Output
1
COPIER> TEST> PG> COLOR-M/C/K
Setting of M-color output at test print
To set whether to output M-color at the time of test print.
The setting is applied to all types.
When setting COLOR-M to 1 and COLOR-Y/C/K to 0, a single M-color is output.
At test print
Enter the setting value, and then press OK key.
0 to 1
0: Not output, 1: Output
1
COPIER> TEST> PG> COLOR-Y/C/K
948
8. Service Mode