Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1037

6. Turn ON the main power switch.
NOTE:
How to Turn OFF the Main Power
1. Turn OFF the main power switch.
2. Check that display in the Control Panel and the lamp of the main power are turned off, then disconnect the power plug.
■ Host Machine Settings (Starting the Setup Guide)
CAUTION:
• The Setup Guide screen appears when the power is turned ON for the first time after the machine is installed. Follow
the instructions displayed on the Touch Panel Display to configure the settings of the host machine.
• It is not possible to exit Setup Guide halfway through.
• Setup Guide can be started again from [Settings/Registration] ( [Settings/Registration] > [Management Settings] >
[License/Other] > [Start Setup Guide]).
• What has been registered in Setup Guide can be changed from items in (Settings/Registration). When configuring
settings using Setup Guide, excluding some of the setting items, it is possible to proceed to the next setting without
entering the current setting. To configure skipped settings, configure the settings one by one after exiting Setup Guide.
If the host machine is turned OFF during registration using Setup Guide, Setup Guide is automatically started by turning
ON the power again. Once registration using Setup Guide has been completed, Setup Guide is not automatically
started by turning ON the host machine.
CAUTION:
Register the information of paper loaded during installation of the host machine.
Be sure to register the correct paper type. Especially in the case of special paper types such as heavy paper, registering
a wrong paper type may result in image failure, and when the Fixing Assembly becomes soiled or paper wraparound occurs,
repair by a service technician becomes necessary.
NOTE:
• Initialization of toner supply, initialization of the Developing Unit, initialization of the drum, and color displacement correction,
etc. are automatically performed while Setup Guide is running.
• When all initializations have been completed, Setup Guide stops (approx.4 minutes).
When not executing Setup Guide, it can be canceled by pressing [Cancel] on the Touch Panel Display. When executing
Setup Guide, follow the Setup Guide to specify the items in the order shown below:
1. <Switch Language/Keyboard>
Select the displayed language and keyboard layout.
2. <Paper Settings>
1. Select the paper source for which you want to specify the paper type, and press [Set].
2. Select the paper type, and press [OK].
3. If [Plain] is selected, the basis weight can be specify from [Plain Paper Weight Set].
4. If a button corresponding to the paper that has been set is not displayed, press [Detailed Settings] and make a selection
on the detailed settings screen.
NOTE:
• If the corresponding paper type is not displayed on the simple settings screen, press [Detailed Settings] and make a selection
on the detailed settings screen.
• If the type of loaded paper is not displayed on the detailed settings screen, you can register it.
1025
9. Installation