Table of Contents
Advertisement
Chapter 5
5.3 FUNCTION
5.3.1 FUNCTION Table
5.3.1.1 FUNCTION Table
CLC5100 / CLC4000
<INSTALL>
FUNCTION > INSTALL
Sub item
INIT
Use it to read in the initial value of the toner density signal (SGNL, REF) of the specified color.
C/M/Y
The value will be indicated on screen 3/4. Record it to the service label.
INIT 3
Reads the initial value of the toner density signal (SGNL, REF) of three colors (C, M, Y) in
sequence.
The value will be indicated on screen 3/4. Record it to the service label.
INIT 7
Reads the initial value of the toner density signal (SGNL, REF) of the ATR and SALT sensors
in sequence.
The value will be indicated on screens 3/4 and 4/4. Record it to the service label.
SINIT
Reads the initial value of the SALT signal (SGNL, REF) of the specified color.
C/M/Y/K
The value will be indicated on screen 4/4. Record it to the service label.
SINIT 4
Reads the initial value of the SALT signal (SGNL, REF) of four colors (C, M, Y, K) in sequence.
The value will be indicated on screen 4/4. Record it to the service label.
STIR
Stirs the starter of the specified color.
C/M/Y/K
STIR 4
Stirs the starters of the four colors.
SPLY
Rotates the cylinder of the developing assembly to supply starter of the specified color.
C/M/Y/K
IMG REG
Turns on or off the image position auto correction function.
0: OFF 1: ON
LSNS KIL
Turns on or off the toner sensor output mode for moving up/down the hopper.
0: OFF 1: ON
Used only at time of installation.
5-46
Operation/Inspection Mode
T-5-30
FUNCTION > INSTALL
Description
Initial: 0
0004-7984
Advertisement
Table of Contents
