Canon imageRUNNER ADVANCE C3330 Series Service Manual page 946

COPIER (Service mode for copier) > OPTION (Specification setting mode) > LCNS-TR
TR-SCR 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-BRDIM 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-BRDIM 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-VNC 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-VNC 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Trns license key dspl: encry secure pnt
To display transfer license key to use encrypted secure print when the function is disabled with
license transfer.
This item is enabled when there is "3DES+USH-H" Board.
- When replacing the HDD
- When replacing the device
1) Select ST-SCR.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-SCR.
24 digits
Install state dspl of BarDIMM function
To display installation state of BarDIMM when disabling the function with license transfer.
When checking whether BarDIMM is installed
1) Select ST-BRDIM.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-BRDIM.
When operation finished normally: OK!
According to the setting at shipment
Trns lcns key dspl of BarDIMM function
To display transfer license key to use BarDIMM when the function is disabled with license transfer.
- When replacing the HDD
- When replacing the device
1) Select ST-BRDIM.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-BRDIM.
24 digits
Install state dspl:remote operators soft
To display installation state of remote operators software when disabling the function with license
transfer.
When checking whether remote operators software is installed
1) Select ST-VNC.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-VNC.
When operation finished normally: OK!
According to the setting at shipment
Trns lcns key dspl:remote operators soft
To display transfer license key to use remote operators software when the function is disabled with
license transfer.
- When replacing the HDD
- When replacing the device
1) Select ST-VNC.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-VNC.
24 digits
934
8. Service Mode