Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1154

Checking the Contents
■ HDD Data Encryption Kit
[1] Encryption Board X 1
[4] Cable Guide X 1
[7] Power Cable
<Others>
Including guides
Setting Before Turning OFF the Power
CAUTION:
Be sure to turn OFF the main power after executing this service mode setting.
Turning OFF the main power without executing service mode causes "E602-5001 (procedure error before installing the
HDD Encryption Board)" to occur when turning ON the main power after installing the Encryption Board. When this error
occurs, the machine needs to be returned again to the initial state in which no Encryption Board is installed.
1. Execute the following service mode (level 1).
• COPIER > Function > INSTALL > HD-CRYP
Check Items when Turning OFF the Main Power
Check that the main power is OFF.
1. Turn OFF the main power switch.
2. Be sure that display in the Control Panel and the lamp of the main power supply are turned off, then disconnect the
power plug.
[2] Signal Cable
[5] Screw (TP; M3x6) X 4
[8] Cable Guide X 1
(135mm; A:Cont-Pow)
X 1
(250mm; A:HDD-Sig)
X 1
[6] Signal Cable
[9] Wire Saddle X 3
1142
[3] Power Cable
(270mm; A:HDD-Pow1)
X 1
(135mm; A:Cont-Sig)
X 1
9. Installation