Canon imageRUNNER ADVANCE C3330 Series Service Manual page 874

COPIER (Service mode for copier) > OPTION (Specification setting mode) > NETWORK
WUEN-LIV 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
IFX-CHIG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
Amount of Change per
Unit
DNSTRANS 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set startup time after sleep notice
To set the time from startup from sleep mode via network without job assignment until the mode
is shifted to the sleep mode again.
When setting the startup time after sleep notification
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 600
sec
15
1
Set operation by IFAX recv e-mail text
To set the number of characters for the IFAX received e-mail text, so that the e-mail is not printed/
forwarded when the characters in the e-mail text is less than the number of specified characters.
When a sender sends e-mail text consisting of linefeed codes only, this machine outputs a blank
paper. In such case, specify 2 (number of characters) so that there will be no output of blank paper.
In the case of specifying any number other than 0, header/footer is printed/forwarded in 1 sheet
only if the e-mail text is less than the specified value while no TIFF file is attached.
As the value is incremented by 1, the number of target characters in e-mail text is increased by 1
character.
When reducing printouts of blank paper due to e-mail received by IFAX
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Be sure to get approval from the user by telling that e-mail text is not printed if the number of
characters is less than the specified value.
0 to 999
0: E-mail text is not ignored.
char
0
A Japanese Kanji character is calculated as 2 bytes, and the control codes (such as linefeed code,
etc) are included in the number of characters.
1
Setting of DNS query priority protocol
To set priority of the protocol (IPv4/IPv6) for DNS query.
In the case of using both IPv6 and IPv4 while the DNS server supports IPv4, it takes time because
of timeout when executing DNS query with priority on IPv6. Giving priority on query by IPv4 can
shorten the time.
When it takes time to execute DNS query with priority on IPv6 because the DNS server supports
IPv4
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: IPv4, 1: IPv6
1
862
8. Service Mode