Function (Operation / Inspection Mode) - Canon imageRUNNER ADVANCE 715iF III Series Service Manual

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > MISC
ACS-EN3
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
ACS-CNT3
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value

FUNCTION (Operation / inspection mode)

■ INSTALL
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > INSTALL
STRD-POS
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Related Service Mode
CARD
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
2 Set of ACS mode jdgmt area: back side
To set the judgment area in ACS mode (back side at duplex reading with 1 path).
As the greater value is set, the judgment area is widened.
When adjusting the judgment area in ACS mode (back side at duplex reading with 1 path)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-2 to 2
1
2 ACS mode jdgmt pixel count area: back
To set the area which counts the pixel to judge the color presence in ACS mode (back side at
duplex reading with 1 path).
As the greater value is set, the judgment area is widen.
When adjusting the area which counts the pixel to judge the color presence in ACS mode (back
side at duplex reading with 1 path)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-2 to 2
0
1 Scan position auto adj in DADF mode
To adjust the DADF scanning position automatically.
At DADF installation/uninstallation
1) Close the DADF.
2) Select the item, and then press OK key.
The operation automatically stops after the adjustment.
3) Write the value displayed by COPIER> ADJUST> ADJ-XY> STRD-POS in the service label.
Write the adjusted value in the service label.
At normal termination: OK, At abnormal termination: NG
COPIER> ADJUST> ADJ-XY> STRD-POS
1 Card number setting
To set the card number to be used for Card Reader.
A series of numbers from the entered number to the number of cards specified by CARD-RNG
can be used.
- At installation of the Card Reader
- After replacement of the HDD
1) Enter the number, and then press OK key.
2) Turn OFF/ON the main power switch.
The card management information (department ID and password) is initialized.
1 to 2001
1
COPIER> OPTION> FNC-SW> CARD-RNG
471
8. Service Mode