Canon imageRUNNER ADVANCE C3330 Series Service Manual page 905

COPIER (Service mode for copier) > OPTION (Specification setting mode) > IMG-FIX
FIXMIXBD 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
FXS-TMP9 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
THIN-LP 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
PRE-FXRL 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Setting of media mixed mode
To set whether image quality or productivity is to be prioritized when media are mixed.
As the value is increased, image quality is improved, but productivity is decreased.
When the value is decreased, productivity is increased, but uneven gloss may occur.
- When a fixing failure occurs while media are mixed
- Upon user's request (to improve productivity when media are mixed)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-2 to 2
0
5
Set ITOP control temp: coated paper 1
To set the offset of ITOP control temperature for coated paper 1 (106 to 128 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Decrease the value when uneven gloss occurs, and increase the value when a fixing failure occurs
on the leading edge of paper.
When uneven gloss occurs on the leading edge (74 mm) of coated paper 1
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, uneven gloss may occur.
If the value is too small, a fixing failure may occur on the leading edge of paper. (Toner does not
peel off.)
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set of fixing arch control: thin paper
To set the arch amount between the secondary transfer and fixing when feeding thin paper (52 to
63 g/m2) at 1/1 speed.
Increase the value when an image failure (crawled marks/wrinkles) occurs.
When an image failure (crawled marks/wrinkles) occurs with thin paper
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-2 to 2
-2: 0 mm, -1: 15 mm, 0: 35 mm, 1: 60 mm, 2: 85 mm
0
Image failure (crawled marks): A symptom that image is blurred in the feeding direction and it
occurs when a deflected paper comes closer to the Fixing Film. If a paper is deflected enough to
be bent, an image failure (wrinkles) occurs.
ON/OFF of Pressure Roller soil prev mode
To set whether to execute Pressure Roller soiling prevention mode when feeding calcium
carbonate paper.
When 1 is set, the paper intervals become wider and temperature of the Pressure Roller is
increased. As a result, soiling on the Pressure Roller can be reduced, but productivity is decreased.
Upon user's request (to prevent soiling on the Pressure Roller)
Enter the setting value, and then press OK key.
Be sure to get approval from the user in advance by telling that productivity decreases.
0 to 1
0: OFF, 1: ON
0
893
8. Service Mode