Library Power Switch - StorageTek L700e Operator's Manual

Library Power Switch

Table 2-1. Operations Guide (Continued)
Task
• Set library Fibre Channel Port 0 address
• Enable/disable Fast Load
• Set date and time
• Set drive configuration
• Set network configuration
• Set screen characteristics
Library Power Switch
The library power switch is a circuit breaker or breakers behind the right front
door of the library.
This switch, attached to the AC power distribution unit (PDU), controls the AC
power to the library and drive column.
The power switch has two configurations:
• A single breaker on the AC power distribution unit controls the library and a
single drive column.
• An optional second breaker, located on the second power distribution unit,
powers the second drive column and an optional second library power
supply.
Notes: If your library has two circuit breakers:
To apply power to the library and drive column, lift the switch or switches.
To remove power from the library and drive column:
• Make sure all jobs are complete.
• Push down on the library power switch or switches.
2-18
Figure 2-18 on page 2-19
1. The optional PDU must be connected to a separate electrical circuit.
2. If only one breaker is powered off, the second breaker will still be
powered on.
Tenth Edition
Page for Operator Panel
Instructions
page 3-5
page 3-7
page 3-8
page 3-10
page 3-12
page 3-15
shows the power switch location.
95845