Configure the Drive
After installation, make sure drive is properly configured as follows:
1. Obtain site specific configuration requirements.
2. Make sure the drive configuration settings match requirements.
Note: For change drive configuration guidance, refer to:
3. Close any open doors and replace any access covers of the library or the
RACK001.
Table 3-3
Table 3-3. Fibre Channel and SCSI Configuration Items
Selection
Compression
Data Security Erase
Port A/B Attributes
SCSI Attributes
Tape Bar Usage
Language
VolSafe
FullCode Load
Emulation
Library Address
CSL Power Up Mode
1
Fibre Channel and SCSI attributes must be set to match specific site
requirements.
2
Full code load is preset to "No", and only applicable single firmware code is
loaded in the drive EEPROM prior to shipment from StorageTek. Refer to
FullCode Load Submenu, on page
information.
3
Library address must be unique as required for specific site installation.
95741
•
"Fibre Channel Change Configuration Menu" on page 6-10
•
"SCSI Change Configuration Menu" on page 6-24
provides a summary of configurable items.
Fibre Channel
Yes
Yes
1
Yes
1
N/A
Yes
Yes
Yes
2
No
Yes
3
Yes
Yes
Sixth Edition
SCSI
Yes
Yes
N/A
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
6-18
or page
6-29
for additional FullCode
Configure the Drive
3-53