Model Vx-Rps-Ch3; Power Cord Requirements For Ac-Powered Switches And Ac Power Supplies; Console Connector Pinouts - Extreme Networks ExtremeSwitching X435 Series Hardware Installation Manual

Technical Specifications

Model VX-RPS-CH3

The following table lists the specifications for the 3-slot modular shelf (model VX-RPS-CH3). The shelf is
designed for use with the following equipment:
•
VX-RPS-1000 Redundant Power Supply
Table 356: Physical Specifications
Length
Depth
Height
Weight
Power Cord Requirements for AC-Powered Switches and AC Power
Supplies
An AC power cord is not included with the AC power supply.
Power cords used with AC-powered switches or AC power supplies must meet the following
requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C13 connector for connection to the switch or power supply.
•
The power cord must have an appropriately rated and approved wall plug applicable to the country
of installation.
•
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
minimum wire size is 16 AWG (1.0 mm
For details about obtaining AC power cords for use in your country, refer to
www.extremenetworks.com/product/powercords/.

Console Connector Pinouts

Table 357 describes the pinouts for a DB-9 console plug connector.
Table 357: Pinouts for the DB-9 Console Connector
Function
DCD (data carrier detect)
RXD (receive data)
TXD (transmit data)
DTR (data terminal ready)
GND (ground)
DSR (data set ready)
RTS (request to send)
CTS (clear to send)
on page 130 (model 18202)
44.0 cm (17.34 in.)
38.7 cm (15.25 in.)
4.4 cm (1.73 in.)
2.89 kg (6.37 lb)
2
).
Pin Number
1
2
3
4
5
6
7
8
ExtremeSwitching Hardware Installation Guide 475
Model VX-RPS-CH3
2
) minimum; over 6 feet, the
http://
Direction
In
In
Out
Out
-
In
Out
In