Extremeswitching X440-G2-12T-10Ge4 Switch Ports And Slots - Extreme Networks ExtremeSwitching X435 Series Hardware Installation Manual

ExtremeSwitching X440-G2-12t-10GE4 Switch Ports and
Slots
All X440-G2 switches support external redundant power options. For details, refer to
120.
Note
See the
for feature-specific information about the switches and for information regarding switch
configuration.

ExtremeSwitching X440-G2-12t-10GE4 Switch Ports and Slots

The ExtremeSwitching X440-G2-12t-10GE4 switch ports and slots include:
•
12 front panel 10/100/1000BASE-T ports (RJ45), all of which support both half-duplex and full-
duplex communication.
•
Four unpopulated 1GBASE-X SFP+ ports that can be used as either 1Gb ports or 10Gb ports, where
the 10Gb configuration requires an upgrade through additional licensing.
Alternately, you can convert two of the ports to stacking ports using the enable stacking-
support command. Doing so would provide you with the option of two 1Gb ports and two stack
ports or two 10Gb ports and two stack ports. In the latter configuration, an additional license would
be required for the 10Gb non-stacking ports.
•
Ethernet management port (10/100/1000BASE-T).
•
Serial console port implemented as an RJ45 connector used to connect a terminal and perform local
management.
•
One front panel USB 2.0 port, operational on switches running ExtremeXOS version 22.2 or later.
•
One rear redundant power supply connector (coaxial barrel connector).
Figure 14: ExtremeSwitching X440-G2-12t-10GE4 Front Panel
1 = Stack number indicator
2 = Console port/Ethernet management port
3 = USB port (active with ExtremeXOS version 22.2 or later)
32 ExtremeSwitching Hardware Installation Guide
ExtremeXOS 30.7 User Guide and the ExtremeXOS 30.7 Command Reference Guide
4 = 10/100/1000BASE-T copper ports
5 = SFP Ports upgradeable to 10GBASE-X
ExtremeSwitching Switches
Table 38 on page