Connecting The Ground Wire To A 450 W Or 550 W Dc Power Supply - Extreme Networks ExtremeSwitching X435 Series Hardware Installation Manual

Connecting the Ground Wire to a 450 W or 550 W DC
Power Supply
3. Push the power supply in until the latch snaps into place.
4. Reconnect the ground wire as described in
Power Supply

Connecting the Ground Wire to a 450 W or 550 W DC Power Supply

To connect the ground wire to the 450 W or 550 W DC power supply:
Warning
Be sure to connect the chassis ground wire before you connect any power cables.
1. Verify that the DC circuit is de-energized.
2. Pull the cover off the terminal block.
3. Identify the grounding point on the front panel of the power supply.
See Figure
Figure 294: Connecting the Ground Wire
1 = Grounding point
4. Connect the ground wire to the grounding point as follows:
a. Loosen the screw enough to allow the spade terminal to slide underneath the captive square
washer (see
b. Slide the spade terminal of the ground wire under the captive square washer.
354 ExtremeSwitching Hardware Installation Guide
Caution
Do not slam the power supply into the switch.
on page 354.
294.
Figure 295).
Connecting the Ground Wire to a 450 W or 550 W DC
2 = Ground wire
Replacing DC Power Supplies