Rps-150Xt Redundant Power Supply - Extreme Networks ExtremeSwitching X435 Series Hardware Installation Manual

Power Supplies for Use with Your Switch
The RPS-90 power supply has a C6-format AC power input connector. As a result, you will need to
obtain both a standard C13 AC power cord and a C5-to-C14 converter (Extreme Networks model
10947).
Note
The converter is not available in China. A special power cord is available for use with the
RPS-90 in China.
The RPS-90 cannot be mounted in a rack.
For technical specifications, refer to
465.

RPS-150XT Redundant Power Supply

Tip
Extreme Redundant Power Supplies (RPS) do not support the ability for the RPS to be
connected to an operational switch. Connecting an RPS to an operational switch can have an
adverse effect on the switch. It is best practice that both the switch and the RPS be powered
down prior to cabling them together. Once the cabling is completed, turn on the RPS, then
turn on the switch.
The RPS-150XT provides backup power to Extreme Networks stackable switches. If for some reason the
switch loses power from its internal power supply, the RPS-150XT can provide up to 150 W maximum
operating power to support switch operation.
The power supply ships with the following:
•
RPS cable
•
Four rubber feet (for flat surface installation)
Figure 116: RPS-150XT Front Panel
1 = Captive screws
2 = Status LEDs
3 = Handle
RPS-90 Redundant Power Supply Technical Specifications
4 = Fan
5 = AC power input connector
ExtremeSwitching Hardware Installation Guide
RPS-150XT Redundant Power Supply
on page
125