Removing And Replacing Expansion Modules; Removing Or Replacing A V300 Virtual Port Extender; Removing Or Replacing A V400 Virtual Port Extender - Extreme Networks ExtremeSwitching X435 Series Hardware Installation Manual

Removing and Replacing Expansion
Modules

Removing or Replacing a V300 Virtual Port Extender

Removing or Replacing a V400 Virtual Port Extender

Removing or Replacing an LRM/MACsec Adapter
Removing or Replacing a Half-Duplex to Full-Duplex Converter
Replacing a Versatile Interface Module, Solid-state Drive, or Clock Module in an
X460-G2 Series or X465 Series Switch
This chapter describes how to replace the following equipment:
•
Removing or Replacing a V300 Virtual Port Extender
•
Removing or Replacing a V400 Virtual Port Extender
•
Removing or Replacing an LRM/MACsec Adapter
•
Removing or Replacing a Half-Duplex to Full-Duplex Converter
•
Replacing a Versatile Interface Module, Solid-state Drive, or Clock Module in an X460-G2 Series or
X465 Series Switch
Removing or Replacing a V300 Virtual Port Extender
For instructions on installing a V300 Virtual Port Extender, refer to
Extender on page 294.
To replace a V300 Virtual Port Extender or remove it from service, follow these steps:
1. Disconnect the port extender from its power source and, if applicable, from its redundant power
supply.
2. Support the port extender while you remove the rack-mounting screws that hold the front mounting
brackets in place against the rack posts.
3. Carefully slide the port extender out of the rack.
4. Place the port extender on a secure, flat surface.
Optionally, remove the mounting brackets from the sides.
5. Install a new port extender using the instructions in
294.
Removing or Replacing a V400 Virtual Port Extender
For instructions for installing a V400 Virtual Port Extender, refer to
Extender on page 316.
370 ExtremeSwitching Hardware Installation Guide
on page 372
on page 372
on page 370
on page 370
on page 371
on page 370
on page 370
on page 371
on page 371
Installing a V300 Virtual Port
Installing a V300 Virtual Port Extender
Installing a V400 Virtual Port
on page 371
on page