Safety During Setup, Maintenance, Service And Repair - ABB FlexLoader Applications Manual

1.3 Safety during setup, maintenance, service and repair

Always ensure that FlexLoader Standard Safety Center cannot be started when
working on the cell. The installed protection that belongs to the equipment must
always remain installed during automatic operation.
Work on mechanical systems must only be carried out by qualified person or by
a trained person under guidance and supervision of a qualified person according
to the applicable technical regulations.
Work on electrical systems or operating material must only be carried out by a
qualified electrician or by a trained person under guidance and supervision of a
qualified electrician according to the applicable electrical technical regulations.
All safety and warning signs must be kept clean and legible. If necessary, replace
them.
Always check the function of all safety devices after performing work that may
have had an impact on the safety systems.
Application manual - FlexLoader Standard Safety Center
3HAC051769-001 Revision: E
1.3 Safety during setup, maintenance, service and repair
© Copyright 2014-2020 ABB. All rights reserved.
1 Safety
11