ABB IRB 6620 Product Manual page 215

Refitting, turning disk
Use this procedure to refit the turning disk.
1
2
3
4
5
6
Product manual - IRB 6620
3HAC027151-001 Revision: T
Action
Lubricate the o-ring of the turning disk with
grease and fit it to the turning disk.
Also fit the six o-rings, when refitting the attach-
ment screws.
Foundry Plus:
Apply Loctite 574 flange sealant on the contact
surface.
Secure the turning disk with its attachment
screws.
Perform a leak-down test of the gearbox axis
6.
Refill the axis 6 gearbox with oil.
Refit any equipment removed during disas-
sembly to the turning disk.
© Copyright 2006-2018 ABB. All rights reserved.
4.4.1 Replacing the turning disk
Note
Art. no. is specified in Required equip-
ment on page 213.
xx0200000218
• A: Sealing surface, o-ring
xx1400000995
6 pcs M14 x 25, 12.9 quality.
Tightening torque: 175 Nm
Reused screws may be used, providing
they are lubricated as detailed in sec-
tion Screw joints on page 342
ting.
Detailed in the section Performing a
leak-down test on page 178.
See section
• Changing oil, axis-6 gearbox on
page 166
Continues on next page
4 Repair
Continued
before fit-
215