Front Panel - Special Functions; Programmable Function Button; Enable Dynamic (Dhcp) Ip Address; Reset To Factory Default Settings - Lightware HDMI-TPS-RX110AY Series User Manual


  
3. Product Overview
3.3. Front Panel - Special Functions
3.3.1. Programmable Function Button
Action or an operation can be assigned to the Functionbutton."Functionbuttonpressed"isaconditionthat
can be selected in the Event Manager. See more details in the
3.3.2. Enable Dynamic (DHCP) IP Address
ThedevicegetsastaticIPaddressasafactorydefaultsetting.Ifthissettingdoesnotfittothecircumstances
duringinstallorusage,DHCPcanbeenabledfromthefrontpanel:
Step 1. Make sure the device is powered on and operational.
Step 2. Press and keep pressed the Function button for 5 seconds.
Step 3. After5secondsfrontpanelLEDsstartblinking;releasethebuttonandpressit3timesagainquickly
(within 3 seconds).
Step 4. TheLEDsgetdark,DHCPgetsenabled.
#dhcp
3.3.3. Reset to Factory Default Settings
Torestorefactorydefaultvalues,dothefollowingsteps:
Step 1. Make sure the device is powered on and operational.
Step 2. Press and keep pressed the Functionbuttonfor10seconds.After5secondsfrontpanelLEDsstart
blinking but keep on pressing the button.
Step 3. After 10 seconds the blinking gets faster; release the button and press it 3 times again quickly (within
3 seconds).
Step 4. TheLEDsgetdark,thedevicerestoresthefactorydefaultsettingsandreboots.
Factory default settings are listed in the
Event Manager section. #function
Factory Default Settings section. #factory
Appliedfirmwarepackage:v1.4.0 | LDCsoftware:v2.4.0b3
HDMI-TPS-RX110AY series – User's Manual
3.3.4. Reseting the Device
Infewcases(afterfirmwareupgrade,etc)youmayneedtoresetthedevice.Pushingtheresetbuttonresults
the same as you disconnect and reconnect the power adaptor to the receiver. To reseting the device follow
thesteps:
Step 1. Push the button with a thin object for a second.
Step 2. Waituntilthedevicereboots.YoucanusethereceiverwhentheLIVELEDisblinkingslowlyagain.
ATTENTION!
Reseting the device does not reset the settings to factory defaults. To reset factory default
settings see previous section.
#reset #restart #reboot
3.3.5. Entering Bootload Mode
Itmayhappenthatthefirmwareupgradeprocessisnotsuccessfulasthedevicecannotbeswitchedto
bootload mode automatically. In this case, receiver device can be forced to switch to bootload mode as
follows:
Step 1. Make sure the transmitter is powered off.
Step 2. Press and keep pressed the Function button.
Step 3. Poweronthereceiver.IfthedeviceisswitchedtobootloadmodetheLIVELEDisblinkingquickly
(lessthan500msdutycycle).TheotherLEDsareoff.
#bootload
19