Control Lock; Bootload Mode Setting; Restarting The Device; Restore The Factory Default Settings - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
7. Programmers' Reference 7. Programmers' Reference
7.3.13. Control Lock
Enable/disable the operation of the jog dial control knob.
Command and Response #controllock
SET•/MANAGEMENT/UI.ControlLock=<parameter>
ç
pw•/MANAGEMENT/UI.ControlLock=<parameter>
æ
Parameters
Identifier Parameter description
Lock/unlock of the jog dial
<parameter>
control knob
Example
ç SET /MANAGEMENT/UI.ControlLock=1
æ pw /MANAGEMENT/UI.ControlLock=1
7.3.14. Bootload Mode Setting
The device can be set to bootload (service / firmware upgrade) mode. The AV signal transmission is
terminated in this mode.
Command and Response #bootload
ç CALL•/SYS:bootload()
æ mO•/SYS:bootload=
Example
ç CALL /SYS:bootload()
æ mO /SYS:bootload=
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
Value Explanation
0 The jog dial control knob is unlocked.
1 The jog dial control knob is locked.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
7.3.15. Restarting the Device
Calling the method results the endpoint restarts – the connection with the remote device and the signal
transmission will be terminated. After rebooting the configuration settings are reloaded and the connection
with the remote device is established again.
Command and Response #restart #reboot #reset
ç CALL•/SYS:reset()
æ mO•/SYS:reset=
Example
ç CALL /SYS:reset()
æ mO /SYS:reset=
7.3.16. Restore the Factory Default Settings
Command and Response #factory
ç CALL•/SYS:factoryDefaults()
æ mO•/SYS:factoryDefaults=
Example
ç CALL /SYS:factoryDefaults()
æ mO /SYS:factoryDefaults=
The device is restarted, current connections are terminated, and the default settings are restored. See the
complete list in the Factory Default Settings section.
79 79