Controllock; Identifyingthedevice; Togglingthedarkmodesetting; Settingthedelayofthedarkmodesetting - Lightware HDMI-TPS-TX226 User Manual

   
7.LW3Programmer'sReference
7.4.8. Control Lock
Enable/disabletheoperationofthefrontpanelbuttons.
Command and Response #lockbutton
SET·/MANAGEMENT/UI.ControlLock=<lock_status>
ç
pw·/MANAGEMENT/UI.ControlLock=<lock_status>
æ
Parameters
Parameter Parameterdescription Values
<lock_status> Front panel button
lockingstatus
Example
ç SET/MANAGEMENT/UI.ControlLock=1
æ pw/MANAGEMENT/UI.ControlLock=1
7.4.9. Identifying the Device
CallingthemethodmakesthestatusLEDsblinkfor10seconds.Thefeaturehelpstofindthedevicephysically.
Command and Response #identifyme
ç CALL·/MANAGEMENT/UI:identifyMe()
æ mO·/MANAGEMENT/UI:identifyMe
Example
ç CALL/MANAGEMENT/UI:identifyMe()
æ mO/MANAGEMENT/UI/identifyMe
#buttonlock
Valuedescription
0 None: all functions of the front panel button are enabled.
The front panel buttons are locked but can be unlocked
1
bybuttoncombination.SeethedetailsintheForced
ButtonLock section
The front panel buttons are locked and cannot be
2
unlockedbybuttoncombination,onlyinLDC(onthe
Statustab)orusingtheLW3command.
Appliedfirmwarepackage:v1.3.2b3 | LDCsoftware:v2.5.7b2
HDMI-TPS-TX200series–User'sManual
7.4.10. Toggling the Dark Mode Setting
TheLEDsofthedevicecanbeswitchedoff,iftheirlightcouldbeannoying.InDarkmode,alltheLEDsare
switchedoff,excepttheLEDsoftheRJ45connectors(EthernetandTPSin).
Command and Response
SET·/MANAGEMENT/UI/DARKMODE.DarkModeEnable=<mode_state>
ç
pw·/MANAGEMENT/UI/DARKMODE.DarkModeEnable=<mode_state>
æ
Parameters
If the <mode_state> parameter is true (or 1), the Dark mode function is enabled, if the parameter is false (or 0),
the function is disabled.
Example
ç SET/MANAGEMENT/UI/DARKMODE.DarkModeEnable=true
æ pw/MANAGEMENT/UI/DARKMODE.DarkModeEnable=true
7.4.11. Setting the Delay of the Dark Mode Setting
TheDarkmodecanbeenabledrightaway,orafteracertaintime.Thus,themodeisenabled,ifnobuttons
arepressedmeanwhile.PressinganybuttonbringsbackthestatusinfoontheLEDswithoutperformingthe
function of the button itself. The delay time can be set by this command.
Command and Response
SET·/MANAGEMENT/UI/DARKMODE.DarkModeDelay=<delay_time>
ç
pw·/MANAGEMENT/UI/DARKMODE.DarkModeDelay=<delay_time>
æ
Parameters
The <delay_time>parametermeansseconds,andthedefaultvalueis60.Ifsetto0,nodelayisapplied,and
the Dark mode can be enabled immediately by the DarkModeEnable property. This delay has an affect to the
wakeFromDarkMode method as well.
Example
ç SET/MANAGEMENT/UI/DARKMODE.DarkModeDelay=5
æ pw/MANAGEMENT/UI/DARKMODE.DarkModeDelay=5
85
#darkmode