Tpcl Mode; Initial Setting - Toshiba B-EP Series Interface Specification

4.2 TPCL MODE

4.2.1

INITIAL SETTING

Writable characters, logo, and PC interface commands must be stored, before the label issue
operation.
(1) Storing writable characters and logos
(Add/change)
NOTES: (1) The storage of writable characters or logos is only performed if it is required.
(2) When the Format Command is not sent before storing a writable character or a
(3) Performing other operations (storing PC interface commands and label issue
(4) If the storage operation is not continued after storing writable characters or logos,
Power ON
No
<New>
Yes
Format Command
Bit Map Writable
Character Command
No
Completion of storing
all characters
Yes
Storing PC interface commands
Label issue operation
logo with the same number as the already stored writable character or logo,
memory will be used with each storing.
operation) after storing writable characters or logos automatically clears the
image buffer.
the printer enters the on-line mode (label issue operation) after approx. 1.6
seconds. At the same time, the image buffer is automatically cleared.
CHAPTER 4 TRANSMISSION SEQUENCE
[ESC] J1: Formats flash memory.
[ESC] XD: Stores writable characters or a
logo on flash memory.
4-2
B-EP Series