Toshiba B-EP Series Interface Specification page 451

6.10 COMMANDS RELATED TO PC COMMAND SAVING
6.10.1 FORM STORE START COMMAND
Function Declares the start of form storage.
Format [ESC] XO; aa, b [LF] [NUL]
Term aa:
b:
Notes (1) Max. 20 types can be stored. However, since the memory capacity is limited, the
(2) The data which is stored most recently is the newest in spite of the version No.
(3) When the form number which has been stored is stored again, the new form can
(4) Until the Form Store Terminate Command ([ESC] XP) is received after the Form
(5) If the Form Store Start Command is not sent, the Label Size Set Command ([ESC]
(6) When there is no free space in the form storage area in flash ROM because of
(7) Since the drawing buffer is cleared after receiving this command, reprint by the
Refer to Form Store Terminate Command ([ESC] XP)
Example To start storing version 3 of form No. 2.
[ESC] XO; 02, 3 [LF] [NUL]
Form No.
01 to 20
Form version No.
0 to 9 (It is not stored when "0" is designated)
maximum number may vary depending on the form size to be stored.
be stored if the Form Store Start Command ([ESC] XO) is sent.
memory is used every time a form is stored again.
Store Start Command ([ESC] XO) is received, any command other than below is
not stored and is ignored.
• Label Size Set Command ([ESC] D)
• Print Density Fine Adjust Command ([ESC] AY)
• Position Fine Adjust Command ([ESC] AX)
• Bit Map Font Field Command ([ESC] PC)
• Outline Font Field Command ([ESC] PV)
• Barcode/Two-dimensional Code Format Command ([ESC] XB)
• Graphic Field Command ([ESC] N)
• Line Format Command ([ESC] LC)
D), the Bit Map Font Field Command ([ESC] PC), the Outline Font Field Command
([ESC] PV), the Barcode/Two-dimensional Code Format Command ([ESC] XB),
and the Graphic Field Command ([ESC] N) are ignored and discarded.
After the Form Store Start Command is sent, the Label Size Set Command should
be sent before each field command, the Print Density Fine Adjust Command, or the
Position Fine Adjust Command is sent.
storing a form, this area is automatically initialized. However, the latest version of
each form is held.
reprint key is disabled.
CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
[ESC] XO
6-70
B-EP Series
However,