Toshiba B-EP Series Interface Specification page 490

7.5.7 BARCODE HEIGHT COMMAND
Function Sets the barcode height.
Format [GS] hn
Term n: Barcode height (1 byte)
Initial value n: 68H (104 dots)
Explanation (1) When "n" is set to any value other than the above, a command error occurs.
* For PDF417, the bar height for one row is set by this command. Note that the height
of the whole barcode cannot be set by this command. The PDF417 can have the
maximum of 90 rows. Therefore, if 88 or more dots are specified, the PDF417 may
not be stored in the image buffer.
guaranteed.
32 dots
64 dots
96 dots
Refer to Barcode/Two-Dimensional Code Print Command ([GS] k)
01H to FFH (1 to 255 dots)
* 8 7 6 5 4 3 2 1 *
* 8 7 6 5 4 3 2 1 *
* 8 7 6 5 4 3 2 1 *
Effective print width (Width of head)
Width of receipt
CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
[GS] h
In that case, the printer's operation is not
Paper feed direction
[GS] h <20H> [GS] k3*87654321*
[NUL] [LF]
[GS] h <40H> [GS] k3*87654321*
[NUL] [LF]
[GS] h <60H> [GS] k3*87654321*
[NUL] [LF]
7-21
B-EP Series