Toshiba B-EP Series Interface Specification page 268

External equipment interface specification

Hide thumbs Also See for B-EP Series:

Table of Contents

Increment/decrement

Printing is performed while the data is incremented or decremented every time a label is

issued. Where the data row exceeds the maximum number of digits (40), the data row

will not be drawn.

Initial value

Zero suppression

Letters and numerals for increment/decrement

For the data string, up to 40 digits (including letters, numerals, and symbols) are possible.

Only the numerals are selected and calculated for incrementing/decrementing, and then

are returned to the previous position to draw the data.

Example of increment/decrement calculation

Initial value

Zero suppression

No. of digits after zero

Zero(s) in a data row is replaced with a space(s) from the upper digits, according to the

designated number of digits. However, if the number of digits after zero suppression is

greater than the data row, the data row will be drawn without performing zero

suppression. Where the data row exceeds the maximum number of digits (40), the data

row will not be drawn.

When the print data including start/stop codes are sent, the start/stop codes are also

counted as a digit each.

Data string to be printed

Drawing data can be programmed by designating the number of digits after the symbol

The maximum number of digits to be printed varies according to the type of barcode.

For codes, refer to the barcode table mentioned later.

CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)

Show Quick Links

Table of Contents