Toshiba B-EP Series Interface Specification page 425

6.5.10 two-dimensional CODE FORMAT COMMAND
Function Sets the format to indicate the position on the label, at which the two-dimensional code
is to be printed and how it is to be printed.
Format [ESC] XBaa; bbbb, cccc, d, e, ff, g, h (, Mi) (, Kj) (, Jkkllmm), nn, o, p [LF] [NUL]
Term aa:
bbbb: Print origin of X-coordinate of the two-dimensional code
cccc:
d:
e:
ff:
g:
h:
Mi:
Kj:
Jkkllmm: Connection setting (Omissible. No connection if this parameter is omitted.)
Two-dimensional code No.
00 to 99
(The same No. must not be used in one form for the bit map font field, the
outline font field, and the two-dimensional code field.)
Fixed at 4 digits (in units of 0.1 mm)
Print origin of Y-coordinate of the two-dimensional code
Fixed at 4 digits (in units of 0.1 mm)
Type of two-dimensional code
T: QR code
Designation of error correction level
L: High density level
M: Standard level
Q: Reliability level
H: High reliability level
1-cell width
01 to 09 (in units of dots)
Selection of mode
M: Manual mode
A: Automatic mode
Rotational angle of two-dimensional code
0: 0°
1: 90°
2: 180°
3: 270°
Selection of model
(Omissible. If this parameter is omitted, Model 1 is automatically selected.)
i = 1: Model 1
2: Model 2
Mask number
(Omissible. If this parameter is omitted, the number is automatically set.)
i = 0 to 7: Mask number 0 to 7
8: No mask
kk = 01 to 16: Value indicating which divided code is connected.
ll = 01 to 16: Number of divided codes
mm = 00 to FF: A value for all data to be printed, to which XOR is applied in
units of bytes (Not divided)
CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
(QR CODE)
6-44
B-EP Series
[ESC] XB