Handling Of Received Data By Command - Toshiba B-EP Series Interface Specification

4.4.3

HANDLING OF RECEIVED DATA BY COMMAND

4.4.3.1 PAGE MODE PROCESSING
If communication is interrupted while data is transmitted from the application and no subsequent
data is transmitted in the next transmission, a command error occurs. When transmission is
cancelled while data is transmitted in page mode, the data may not be properly stored because
data subsequently transmitted is processed in page mode unless the Page Mode Terminate
Command [FF] or Page Mode Cancel Command [CAN] is issued before the transmission is
cancelled. If communication is interrupted while data is transmitted in page mode, it is necessary
to issue the Page Mode Terminate (Print) Command or Page Mode Cancel Command, turn off
and on the power of the printer, or reset the printer.
However, please note that when the Page Mode Terminate (Print) Command is issued, all
previous data is erased.
[Command transmission and print results (Examples)]
(1) When transmitting data in page mode as usual,
[GS]C
DATA001[LF]
DATA002[LF]
DATA003[LF]
DATA004[LF]
DATA005[LF]
DATA006[LF]
[FF]
Print result:
1st label data
Data is properly printed (as shown below).
DATA001[LF]
DATA002[LF]
DATA003[LF]
DATA004[LF]
DATA005[LF]
DATA006[LF]
CHAPTER 4 TRANSMISSION SEQUENCE
4-47
B-EP Series