Toshiba B-EP Series Interface Specification page 216

External equipment interface specification
Hide thumbs Also See for B-EP Series:
Table of Contents

Advertisement

(3)
The Bit Map Font Format Command may be connected to the Outline Font Format
Command when transmitted.
[ESC] P C001; 0100, 0150, 1, 1, A, 00, B [LF]
C002; 0350, 0180, 1, 1, A, 00, B [LF]
C005; 0200, 0300, 25, 2, C, +05, 00, B, +0000000001 [LF]
V01; 0500, 0400, 0100, 0100, A, 00, B [LF] [NUL]
(4)
When the drawing data differs for every label, the field of the drawing data for the previous
label is automatically cleared using the character string number, then the next drawing
data is printed. Therefore, the character string number should be designated so that they
differ according to the drawing fields.
Since the automatic field clear is not performed between the Clear Command ([ESC] C)
and Issue Command ([ESC] XS), the fixed data may be drawn using the same character
string number. In this case, the Format Command and Data Command should be sent
alternately. (After the Issue Command is sent, the fields with the same character string
number are automatically cleared until the Clear Command is sent.)
(5)
The link field designation is cleared by omitting the link field designation using the same
character string No. and reformatting data.
The link field designation can be also cleared by the Image Buffer Clear Command.
(6)
A print data string and link field No. cannot be programmed at the same time.
(7)
When the (reserved) area for the font type is designated, the bit map font format is not
specified.
(8)
In the case of the compatible mode for the B-SP series, the reserved area is not checked.
(9)
For character sets from 41 to 43, a character code consisting of 1 byte is stored.
However, when the character code is read, F0H is added to the upper digit or FFH is
added to the upper digit with Chinese characters installed, and consists of 2 bytes. In this
case, up to 188 characters can be stored per character set.
• Bit Map Font Data Command ([ESC] RC)
Refer to
• Outline Font Format Command ([ESC] PV)
• Barcode Format Command ([ESC] XB)
CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
5-46
B-EP Series

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents