Toshiba B-EP Series Interface Specification page 235

(3) The Outline Font Format Command may be connected to the Bit Map Font Format
Command when transmitted.
[ESC] PC001; 0100, 0150, 1, 1, A, 00, B [LF]
C002; 0350, 0180, 1, 1, A, 00, B [LF]
C005; 0200, 0300, 25, 2, C, +05, 00, B, +0000000001 [LF]
V01; 0500, 0400, 0100, 0100, A, 00, B [LF] [NUL]
(4) When the drawing data differs for every label, the field of the drawing data for the
previous label is automatically cleared using the character string number, then the next
drawing data is printed. Therefore, the character string number should be designated so
that they differ according to the drawing fields.
(5) Since the automatic field clear is not performed between the Clear Command ([ESC] C)
and Issue Command ([ESC] XS), the fixed data may be drawn using the same character
string number. In this case, the Format Command and Data Command should be sent
alternately. (After the Issue Command is sent, the fields with the same character string
number are automatically cleared until the Clear Command is sent.)
(6) When characters overlap due to the character-to-character space fine adjustment, the
outline font is not painted properly.
characters will not overlap.
positioned over the outline font area, the outline font is not painted properly. For font
types A, B and K, the fine adjustment value should be set so that other drawings do not
overlap the area in which the outline font is to be drawn. For font types E, F and G, the
fine adjustment value should be set so that other drawings do not overlap the area of the
designated character width and height.
(7) The link field designation can be cleared by omitting the link field designation using the
same character string No. and reformatting data.
The link field designation can also be cleared by the Image Buffer Clear Command.
(8) A print data string and link field No. cannot be programmed at the same time.
(9) In the case of the compatible mode for the B-SP series, the reserved area is not checked.
• Outline Font Data Command ([ESC] RV)
Refer to
• Bit Map Font Format Command ([ESC] PC)
• Barcode Format Command ([ESC] XB)
CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
Program the fine adjustment value so that
Also, when drawings such as lines or characters are
5-65
B-EP Series