Toshiba B-EP Series Interface Specification page 443

6.7 COMMANDS RELATED TO FORMAT
6.7.1 FLASH MEMORY STORAGE AREA FORMAT COMMAND [ESC] J1
Function Formats (Initializes) the form storage area in flash memory.
Format [ESC] J1; a [LF] [NUL]
Term a:
Explanation (1) When the storage area in flash ROM becomes full, the old data is automatically
(2) The remaining capacity of flash memory after formatting is displayed on the LCD.
(3) Whenever already registered data (PC saving, writable character or logo) is
(4) After a format command is sent, the image buffer is cleared automatically.
Note (1) Since the writable character storage area is shared by the LABEL and TPCL
Refer to Form Store Start Command ([ESC] XO)
Format (Initialization) designation
A: Form storage area
B: Writable character storage area
C: Graphic storage area
D: All storage areas (Form, Writable character, Graphic)
deleted and only the newest data is left.
Only the form storage area in flash ROM can be forcefully cleared by this
command. However, if this command is sent, all data of the stored forms,
including the newest data, is deleted (initialized).
registered again, memory is consumed unless a format command is sent.
modes, writable characters registered in TPCL mode are erased.
CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
6-62
B-EP Series