Toshiba B-EP Series Interface Specification page 211

(7) Selection of character attribution
A
Black characters
A
Boxed characters
If the print ratio of one line (the print head width) is higher than defined, printing may
become poor, or the printer may be reset.
how to clear and the black dot pattern is increased, be careful about the print ratio.
(8) Bold character designation
0°
Horizontally Vertically
bold bold
(9) Check digit to be attached
When Modulus 10 or Modulus 43 is selected, the check digit of a data row is calculated
and attached to the data row for drawing. In case of Modulus 10, when the data includes
any data other than numerals, drawing is not performed. In case of Modulus 43, when
the data includes any data other than CODE39, drawing is not performed, either.
When DBP Modulus 10 is selected, the check digit of a data row is calculated and only the
check digit is drawn. When the data includes any data other than numerals, drawing is
not performed.
When the font type is U, V, r, s or w, the check digit cannot be designated.
(Even if it is designated, it is ignored.)
* DBP Modulus 10 is Modulus 10 for Deutsche Bundespost Postdienst only.
B
No. of dots in the
horizontal direction
No. of dots in the
B
vertical direction
Vertically/
horizontally
bold
5-41
CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
No. of dots in the
horizontal direction
A B
Reverse characters
No. of dots in the
horizontal direction
A B
Stroked out characters
When "Reverse character" is selected for
90°
Horizontally Vertically
bold bold
B-EP Series
No. of dots in the
vertical direction
Vertically/
horizontally
bold