Toshiba B-EP Series Interface Specification page 576

8.10.33 RELATIVE POSITION SET COMMAND
Function Specifies a relative position.
Format [ESC] \nLnH
Term ASCII: ESC \
Hex: 1Bh 5Ch
[Parameter]
n: No. of dots to specify relative position (low order)
n: No. of dots to specify relative position (high order)
Default value Not defined.
Explanation (1) A relative position of the subsequent print starting position is specified with
reference to a current position. The next print starting position is located (nL + nH
× 256) away from the current position.
(2) A relative position out of the print area is ignored.
(3) If the right direction of the current position is specified, a positive number must be
defined. If the left direction of the current position is specified, a negative number
must be defined.
(4) A negative number is represented by a complement number of 65535.
Ex.) To specify N dots in the left (negative) direction
(5) Dots in the horizontal direction (x) are applied in standard mode.
(6) The printer operation varies in page mode depending on the starting position as
follows:
1 If "top left" or "bottom right" is selected as the starting point in the Page Mode
2 If "top right" or "bottom left" is selected as the starting point in the Page Mode
Reference Absolute Position Set Command ([ESC] $)
nL + nH × 256 = 65536 - N.
Print Direction Set Command ([ESC] T), a relative position in the direction
perpendicular to the paper feed direction (horizontal direction of a character) is
specified.
Print Direction Set Command ([ESC] T), a relative position in the paper feed
direction (horizontal direction of a character) is specified.
CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
[ESC] \
8-49
0 ≤ nL ≤ 255 (00h ≤ nL ≤ FFh)
0 ≤ nH ≤ 255 (00h ≤ nH ≤ FFh)
B-EP Series