Toshiba B-EP Series Interface Specification page 90

RECEIPT mode (Storing graphics)
Request for a Bluetooth
connection
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior
to a data transmission.)
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
Graphic command
[ESC]SG; . . . [LF][NUL]
Request for a disconnection
of the Bluetooth connection
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Host Printer
STX Printer ID Printer status Battery level
02H xxHxxH
STX Printer ID Printer status Battery level
02H xxHxxH
3-59
Response to the request for a Bluetooth
connection
Status sent in response to the status
request command.
00H
Make sure that the printer is
in idle state.
Status indicating a normal termination of data
storage
10H
Normal termination
Response to the request for the disconnection
of the Bluetooth connection
CHAPTER 3 INTERFACE
B-EP Series
Confirmation
of the printer
status prior
to data
storage
xxH
Data
storage
xxH