Toshiba B-EP Series Interface Specification page 649

Notes (1) Each fine adjustment value is backed up in memory (even if the power is turned
off).
(2) Each parameter is set to 0.0 mm at the time of shipment from the factory.
(3) The fine adjustment value for print position and strip position changed by the
Position Fine Adjust Command in the TPCL mode, is also effective in the LABEL
mode.
(4) When print position fine adjustment or strip position fine adjustment is set in the
SYSTEM mode (through printer key operations), each fine adjustment value is a
sum of the value set by this command and the value set in the SYSTEM mode.
However, the maximum fine adjustment value is as follows:
Print position fine adjustment:
Strip position fine adjustment:
When the sum of the fine adjustment value for print position exceeds ±50.0 mm,
the fine adjustment value is corrected to ±50.0 mm during printing.
When the sum of the fine adjustment value for strip position exceeds +3.0 mm in
the + (backward) direction or -2.0 mm in the – (forward) direction, the fine
adjustment value is corrected to +3.0 mm or -2.0 mm, respectively, during printing.
(5) Strip position fine adjustment is effective only in strip issue mode.
(6) The fine adjustment value for strip position up to V1.0C is valid only when the fine
adjustment value for print position is not selected (fine adjustment value = 0).
(7) The fine adjustment value for strip position is selected in the negative direction, a
label is stopped backward against the print start position. However, the print start
position is misaligned by the set value because no back feed is performed in strip
issue mode.
arrows for – 2.0 mm when the label-to-label gap is 3 mm in P.5-15.
(8) When the label pitch length is 20.0 mm or more but less than 24.0 mm and the
effective print length is 15.0 mm or more or the label pitch length is 24.0 mm or
more, a back feed is performed before printing.
CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
±50.0 mm
-2.0 mm to +3.0 mm
(When the label-to-label gap is less than 5 mm) * Refer to the
10-10
B-EP Series