Toshiba B-EP Series Interface Specification page 676

11.2 REPRINT FUNCTION
11.2.1 LABEL MODE
When the batch issue mode is selected, the same label as the last one issued is printed out by
pressing the [FEED] key. When the [FEED] key is pressed if no label has been printed, the
specified label pitch length of one label is fed. (If no sensor is designated, a 20-mm feed is
performed.)
In the strip issue mode, the specified number of labels is issued regardless of whether the
compatible mode for the B-SP series is enabled or not.
If an error occurs, the drawing buffer data is kept until the next Data Print Command is received.
Therefore, after the error is cleared, if the reprint key is enabled in the Data Print Command, one
label can be issued every time the [FEED] key is pressed.
11.2.2 RECEIPT OR ESC/POS MODE
A label is not issued again. A 20-mm feed is performed every time the [FEED] key is pressed.
11.2.3 TPCL MODE
A label is not issued again. The specified label pitch length of a feed is performed every time
the [FEED] key is pressed. (If no sensor is designated, a 20-mm feed is performed.)
11.2.4 TPCL1 MODE
When the batch issue mode is selected, the same label as the last one issued is printed out by
pressing the [FEED] key. When the [FEED] key is pressed if no label has been printed, the
specified label pitch length of one label is fed. (If no sensor is designated, a 20-mm feed is
performed.)
If an error occurs, key entries are ignored. However, the drawing buffer data is kept until the
next Data Print Command is received. Therefore, after the error is cleared, one label can be
issued every time the [FEED] key is pressed.
11.3 POWER SAVE MODE
This printer will enter the power save mode after the printer has been in an idle state for the
specified 'time to the power save mode' to save the power consumption. When the printer enters
the power save mode, all data in the receive buffer is cleared. During an error state (including a
low battery state), the printer does not enter the power save mode, but turns off according to the
auto power off time setting. If the auto power off time is set to 5 minutes or longer, however, the
printer will turn off in 5 minutes.
The power save mode is cleared when:
• The IrDA link is established. (TEC Protocol, IrCOMM)
• A USB cable is connected, and USB communications are started.
• RS-232C communications are started.
• Bluetooth communications are started.
• Wireless LAN communications are started.
• The cover is closed.
• The [FEED] key is pressed.
• The [POWER] key is pressed.
11-2
CHAPTER 11 OTHER FUNCTIONS
B-EP Series